This half clamp allows mounting of mirrors with M10x125 right-hand threads (threading like a standard bolt) directly onto your Beringer lever assembly.
Compatible only with clutch and front brake master cylinders from Beringer.
This bracket is compatible with all our Ø8 and Ø10 mirrors.
Available in black only.
Note, the part is not symmetrical — be sure to choose the side you need if you fit your mirror in the normal (upward) position.
If you wish to mount your mirror under the handlebar (downward), choose the opposite side.
Variants to choose from:
Handlebar diameter: ø22 mm / ø 1 inch (25.4 mm)
Mounting side: left side (clutch) / right side (brake master cylinder)
Half-clutch lever mirror mount to fit an M10x125 mirror on Beringer controls.
Part allowing direct screwing of an M10x125 mirror (right-hand thread) onto Beringer clutch and front brake master cylinder controls. Provides a clean, integrated mounting for our Ø8 and Ø10 mirrors. Available in black only.
Benefits
Specifications
Installation
Screws directly into the Beringer control using the M10x125 thread. The part is not symmetrical: choose the side matching your setup. For a mirror in the normal (upward) position choose the corresponding side; for an under-handlebar (downward) mount choose the opposite side.
Compatibility
Compatible only with Beringer clutch controls and front brake master cylinders. Compatible with all our Ø8 and Ø10 mirrors.
Note: returns are not accepted on Beringer products.
You might also like
