Thruxton (2004-2016)

Thruxton (2004-2016)

Showing 1-6 of 6 item(s)

Flat fuel cap for Triumph

Flat fuel cap for Triumph 2

Parts

Flat tank cap for Triumph

Finish in black only, without a locking system. Made with a black anodized treatment for lasting durability and impeccable style. This product has been carefully selected by the BAAK workshop team for its elegant aesthetic and superior quality. It installs easily as a direct replacement for the original cap.

Regulator bracket for Triumph (pre-2016)

Regulator bracket for Triumph (pre-2016) 2

-20%

Triumph

Regulator bracket for Triumph (pre-2016)

€24.00 €30.00

Time left

Regulator mounting plate for Triumph (pre-2016 - air-cooled). This bracket allows the voltage regulator to be relocated to the horn position. The horn can then be mounted below, on the same plate. Compatible with our Front turn signal bracket for Triumph. Laser-cut aluminium. Installation requires relocating your wiring harness under the tank. All...

Clamps for exhaust wrap

Clamps for exhaust wrap 2

Parts

Clamps for exhaust wrap

This set of 8 self-locking stainless steel clamps will allow you to properly attach the heat wrap to your exhaust. Don’t tell us you were just going to do that with twisted wire. Supplied as 8 units.

Motogadget M-Tri for Triumph (pre- 2016)

Motogadget M-Tri for Triumph (pre- 2016) 2

Triumph

M-tri Motogadget control unit for Triumph (before 2016)

M-TRI multiplexing unit manufactured by Motogadget for Triumph Bonneville, Scrambler, Thruxton EFI from 2011 to present (electronic speedometer). Essential to remove the original speedometer, because without it the motorcycle will not start. This unit restores all original functions and allows fitting any speedometer. It is the unit used in the...

View

Monza type tank cap for Triumph

Monza type tank cap for Triumph 2

Triumph

Monza-style fuel cap for Triumph

Monza fuel cap for Triumph. The legendary Monza-style caps will fit your Triumph tank using our specific adapter. Compatible with new generation Triumphs (2016-...) and older generation (pre-2016 - air-cooled). The complete kit includes the adapter, sealing gasket, screws and the Monza cap. The Monza caps are made from aluminum, polished finish.Beware of...

Thermal wrap

Thermal wrap 2

Parts

Heat wrap

Here are 15 metres of 5cm-wide exhaust wrap to swaddle your exhaust and give you a BAD BOY look! For the black colour, it is strongly recommended to paint it with a high-temperature special paint; otherwise the colour will not hold long and your exhaust wrap will turn grey. Premium quality wrap — beware of low-cost imitations! The 8 stainless steel...

View